due toSteel wire braided rubber hoseThe complexity, structural diversity, and usage conditions of rubber hoses determine not only their product quality, but also their use and maintenance. Therefore, even if the product quality is high, if it is not used and maintained correctly, its quality and service life will be seriously affected. What are the requirements during the installation process.

1. Avoid distortion

Twisted installation will seriously reduce its performance and lifespan, and twisted rubber hoses will generate loosening torque at the joints, which can easily cause the nuts of the joints to loosen, leading to leakage or even hose rupture. If the hose is inevitably twisted, the twisting angle should not exceed 5 degrees.

2. There should be sufficient bending radius during installation

A sufficiently large bending radius (i.e. leaving a suitable length) can prevent damage and throttling of the hose. A bending radius that is too small can seriously reduce the service life of the hose, generate a large amount of pressure loss, and reduce work efficiency.

3. There should be sufficient free length L ≥ 1.5D (D is the outer diameter of the hose)

4. Use elbows and accessories

When the hydraulic pipeline is complex, choosing appropriate elbows and accessories can reduce the amount of rubber hoses used, minimize bending and twisting of rubber hoses, avoid additional stress on steel wire braided rubber hoses, and make the layout more beautiful, neat, and reasonable.

5. There should be compression margin

Pressure can cause changes in the length of the hose, with a range of up to -4% to 2%. Therefore, a margin should be left during installation. Otherwise, long-term use may cause leakage at the joint, and even cause the joint to be pulled out of the hose.

The above are the installation requirements for steel wire braided rubber hoses. If operated improperly during use, the service life will be greatly reduced. Therefore, careful observation should be made during daily use.