Steel wire braided rubber hose is an important component of the hydraulic system of construction machinery. It is often exposed to high temperature, high pressure and other working environments during use. Its service life depends not only on the quality of the hose, but also on its correct maintenance. Therefore, even if the product quality is high, if it cannot be used and maintained correctly, it will seriously affect the quality and service life of the hose, and even cause problems that should not have occurred, resulting in losses. Here are some things to pay attention to:

1. The hose assembly can only be used to transport the corresponding materials, otherwise it will reduce its service life or cause malfunctions.

2. Rubber hose components can only be used within their load-bearing range and must not be used under pressure exceeding the design working pressure.

3. The temperature of the medium conveyed by the hose assembly cannot exceed -40 ℃ -120 ℃, otherwise it will shorten the service life.

4. The hose assembly should be used within the specified bending radius to avoid bending or warping near the pipe joint, otherwise it may hinder hydraulic transmission and material transportation or damage the hose assembly.

5. Cannot be used in a twisted state.

6. During transportation, the steel wire braided rubber hose and components should be handled carefully, and should not be dragged on sharp or rough surfaces, nor bent or squeezed.

7. It should be kept clean and the interior should be kept clean to prevent foreign objects from entering and damaging the equipment.

The quality of steel wire braided rubber hoses directly affects the normal application of equipment, so quality inspection needs to be highly valued. Good consistency is required, which is quality inspection. Each layer of solid must have high adhesion, and the strong adhesive in the middle of each layer forms a whole. In the production and manufacturing of rubber hose components, it is necessary to strictly inspect whether the inner diameter and diameter of the solid layer meet the requirements, to ensure the balance between the bonding amount and quality of the rubber hose joints.